Design Of Men'S Shoes With High Waistline

The structure of the cover can also be applied to high waist shoes. Its design pattern is: the contour of the high waist shoe, the structure of the ten shoe.

1. finished product drawing

As shown in Fig. 5-1-10, the front part of the shoe is made up of the round bar and the tongue cover part. The double line pick up method is adopted.

The back of the shoe is a loose back type, but the shoe is longer and the back is higher.

The height of the back band is 90 to llOmm, and the length of the shoe is 120 to 125mm.

 

2. structure design drawing

As shown in Figure 5 -1-11, the steps of drawing the structural diagram are as follows:

 

(1) determine the height and length of the rear support to determine the direction of the half panel on the Cartesian coordinates, mark the natural stilts and connect the 4 basic control lines.

The height of B'is measured from the height of the last point to the height of 90mm, and the vertical line of the vertical axis.

The Y point at the back end of the last port is set at or above 5mm, making the heel arc curve and connecting with the Y point and setting the T'point on the T line.

Because the shoe tongue is attached to the back of the last, the T point is determined directly by the length of the last face.

TT "length is still the basic length of the shoe.

(2) to determine the outline of the tongue and shoe, as the back of the shoe is hidden under the tongue, the contour of the back of the tongue should first be determined.

Through T, point the vertical line of the back midline, take the width of the tongue of the shoe around 40mm, and draw the outline of the back of the tongue.

The rubber band position of the back band is measured back from the front tarsal protruding point to 24mm and 15mm from the back midline.

From the upper end of the rubber band to the contour line of the shoe, the difference between the inside and outside is made.

The bottom of the white rubber band is continuously pressed.

(3) the front part of the front design is the structure of the cover shoe.

First, the replica board is made, and the contour of the shoe cover is designed by using the replica board in the back line of the straight line. The length difference between 1 / 3 is added to the length of the cover, and the arc of the enclosure reaches O'point.

And make the difference between the inside and outside.

Then use the replica board to design the contour line of the wrap around the curve line, and pay attention to the length difference of one part after J'.

Also make the difference between the inside and outside, and connect to O'point.

The O'point is the pick up position of the cover. The location of the lock line is at O point, slightly higher than the O' point, about 1 / 2 of the length behind the tongue.

Because the shoes of the high waist shoes are longer and the tarpaways are raised, it is not a problem to wear shoes. If the locking position is too close, there will be an empty feeling.

At the same time, we should pay attention to the processing of the bottom.