Five Points For Attention In Decoration And Four Basic Tests

Although these items are familiar to many people, it is still necessary to add new knowledge to families for the first time.

Five points should be kept in mind when decorating, and do not forget to do several checks and tests when finishing decoration.

Five points of attention when decorating

First, building floors should not be paved with marble.

Marble is more than a few times heavier than floor tiles and wooden flooring. If all the floor is paved with marble, it may make the floor overburdened.

In particular, two floors or more, because the house was not identified by the housing safety appraisal station.

The weight of its floor decoration materials shall not exceed 40 kg / m2.

Second, do not pierce holes on the load-bearing wall.

Do not change the load bearing wall or remove the walls that connect the balcony and doors and windows, expand the size of the original doors and windows or build windows and doors. This practice will cause partial cracks in buildings and seriously affect the seismic capacity, thereby reducing the service life of buildings.

Third, we should not go too far in pursuit of luxury.

On the four walls, the ceiling is covered with two or three layers of solid ceiling. This decoration looks luxurious, but in fact it is not desirable.

Because the four walls are full of boards and occupy larger space, the area of the whole space will be reduced, the cost will also be higher, and it will not be conducive to fire prevention.

If the ceiling is too low, the whole room will feel depressed.

Fourth, do not use aluminum wire.

Because the electrical conductivity of aluminum wire is poor, the wires in use are easy to generate heat, loose joints and even cause fires, so copper wires should be used for wires.

In addition, in construction, we should also pay attention to not directly laying the wires on the walls. We should use regular casing installation to avoid leakage and fire.

Fifth. Kitchen kitchens should not be placed on wooden floor cabinets, nor can they be wrapped in wooden floor cabinets.

Once the cabinet is on fire, the gas main valve will be difficult to shut down in the fire, and the consequences will be unthinkable.

Water pipe, discharge tube at the nearest distance, at least the interface as the standard, the tube should be straight and neat, as little as possible, bending and overlapping; indoor all use copper tube, hot water with copper tube, water PVC pipe, the interface should use waterproof adhesive tape; installation basin and sitting level to level and four; kitchen, toilet must have floor drain; install to test water.

The floor and polished floor are pits and scratches. The corners need to be ground with a grinding machine. The floor should be used at least three times with wax oil; the floor should be covered with the foot line; the wooden floor should be made of plywood; the bottom of the board should be lined with oil proof paper or plastic film, and the four edges should be reserved.

The wooden board should be smooth and smooth without any scratches, burrs and burrs. The pattern is clear, the paint surface is uniform and uniform, the gap is tight, the joint position is staggered, the surface is clean, and the seam is straight and square.

In the aspect of bonding, it must be firmly bonded, clean surface, no overflow glue, and the floor blocks are arranged reasonably and beautiful.

The seams are tight, the surface is smooth and smooth, the seams are arranged reasonably and beautiful, the upper ends are straight, and the cutting angles are accurate.

The wood floors are hard to wax, wipe soft wax and wax sprinkled evenly, not smooth, bright and uniform.

Ceramic tile and brick surface should be set flat, the angle should be accurate, the interface should be right line, the toilet floor should have an appropriate slope, and no water can be accumulated; after the tile interface is cleaned, the whitening cement should be brushed with cane wire, and cement stains should not be left on the brick surface.

After the wallpaper and the wall, brush the waterproof oil first, and polish it for more than 5 times. Every time you use the uniform sandpaper, the gap must be repaired immediately. You can not see the concave position of the convex wall with the naked eye. You should use your hands to touch the big concave convex.

Paint and surface

Correct, uniform, smooth and smooth, without tear drop, too thick, bottom, bubbling and so on; the paint border is straight and neat, and no oil is out of bounds; the wall body does not show bumps and holes, and the corners of the walls are smooth.

The interface between boards and boards, boards and walls should be pasted after the rubberized fabric. The latex paint should not be seen at the distance of 1 meters, and the color of the nails should be accurate and smooth.